Honeywell UDC 2300, Product Manual

Page: 165 / 185

Function Parameter Reference Guide
12/00 UDC2300 Controller Product Manual 155
12.2.96 SP SEL
(SETPOINT SELECT FUNCTION LOCKOUT)
This prompt is part of the Tuning Set up group.
This selection allows you to disable/enable the Setpoint Select function.
“LOCK” must be set to “NONE”.
Selections Definitions
DIS Disables the Setpoint Select Function.
ENAB
Enables the Setpoint Select Function.
12.2.97 SP TRK
(SETPOINT TRACKING)
This prompt is part of the Control Set up group.
The local setpoint can be configured to track either PV or RSP as listed below.
ATTENTION
For selections other than NONE, LSP is stored in nonvolatile memory only when there is a mode change;
i.e., when switching from RSP to LSP or from Manual to Automatic. If power is lost, then the current LSP
value is also lost.
Selections Definitions
NONE NO TRACKING—If local setpoint tracking is not configured, the LSP will
not be altered when transfer from RSP to LSP is made.
PV PROCESS VARIABLE—Local setpoint tracks the PV when in manual.
RSP REMOTE SETPOINT—Local setpoint tracks remote setpoint when in
automatic. When the controller transfers out of remote setpoint, the last
value of the remote setpoint (RSP) is inserted into the local setpoint.
12.2.98 START
(TIMER START SELECTION)
This prompt is part of the Timer Set up group. This selection allows you to select
whether the Timer starts with the keyboard
RUN/HOLD
key or Alarm 2.
Selections Definitions
KEY Starts with
RUN/HOLD
key.
AL2 Starts on Alarm 2.
12.2.99 STATE
(PROGRAM STATE AT PROGRAM END)
This prompt is part of the Setpoint Ramp/Program Set up group.
The program state selection determines the program state after completion.
Selections Definitions
DIS
Program disabled at program end.
HOLD Program held at program end.