Honeywell AlarmNet 7810iR-ent, Installation And Setup Manual

Page: 9 / 104

2-1
S E C T I O N 2
7810iR-ent Setup
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Mounting the 7810iR-ent
UL
The 7810iR-ent is intended for dry, indoor use only.
To mount the 7810iR-ent, complete the following steps:
1. Detach the case back by pushing up into the two tabs located at the bottom of the
7810iR-ent with a screwdriver blade while pulling the case back and case front apart.
2. Locate the case back over the mounting surface such that the opening in the case
back is aligned with the wire/cable access opening (in the mounting surface) while
passing the wires/cable through the opening in the case back.
3. Secure the case back to the mounting surface using four screws (supplied).
For UL Commercial Fire/Burglary installations, mount the 7810iR-ent in a 19" UL Listed
Rack Panel as shown below. To do this, complete the following steps:
1. After separating the case back from the case front, as described in Step 1 above, align
the case back over the Rack Panel and drill four mounting holes aligned with the
existing mounting holes in the case back (of the 7810iR-ent).
2. Drill a large hole in the center of the Rack Panel aligned with the existing wire/cable
access opening in the case back (of the 7810iR-ent). Insert grommet into the large
center hole to protect wiring from any sharp edges prior to passing wires/cable
through the opening.
3. Secure the case back to the Rack Panel using four screws and nuts (supplied).