Honeywell AlarmNet 7810iR-ent, Installation And Setup Manual

Page: 76 / 104

7810iR-ent Internet/Intranet Alarm Receiver Installation and Setup Guide
6-10
Message Definition Applies to
cccc 5555 5535 6 System Supervisory Fault Restore 7720ULF
cccc 5555 5565 6 System Supervisory Fault Previously Reported 7720ULF
cccc 5555 5551 6 Walk Test 7720ULF
cccc 5555 5553 6 Walk Test Exit 7720ULF
cccc 5353 5555 6 Exiting Battery Charge Mode 7720V2
Status Channel = 7 (Alarm condition)
NOTES: Each channel that displays these message types corresponds to a particular type of
event. Because there are eight channels, it is possible for multiple events to be reported in
multiple channels in only one message.
(Example: “cccc 1553 5555 7”
indicates an alarm on zone 1 and a restore on zone 4.)
Message Definition Applies to
cccc zzzz zzzz 7 Zone Fault
z = zone number corresponding to the channel position
(1 – 8)
1 = new zone fault
2 = opening (system disarmed)
3 = zone restore
4 = closing (system armed)
5 = normal zone condition
6 = previously report zone fault
Example:
1234 5515 5555 7 indicates a new alarm on zone 3.
1234 5165 5555 7 indicates a new alarm on zone 2, with
a previously reported, un-restored condition still on zone
3. (i.e. The ‘6’ in the third channel indicates that
previously, zone 3 had gone into alarm, was reported in a
message with a 1 in channel three, and remains
violated.)
1234 5335 5555 7 indicates a restore on zones 2 and 3.
I.e. the conditions that caused the alarm on zones 2 and
3 have returned to a normal state.
Note: Sending restoral signals are optional in
programming.
Example:
1234 5525 5555 7 indicates an Opening message.
1234 5545 5555 7 indicates a Closing message.
Open/Close signals are typically sent via the Control
Panel’s Dialer; however they may be optionally
programmed to be sent via the radio as well.
Open/Close messages will be sent on a particular
channel when the radio is programmed properly and
All