Honeywell 3-144, Programming Manual

Page: 79 / 214

Galaxy 3 Series Programming Manual
73
8 = Activity Mon.
This attribute allows a zone to be checked for activity during a set time period or set/unset cycles. The options
are:
• 0 = None
• 1 = Type1
• 2 = Type2
• 3 = Type3
• 4 = Type4
• 5 = Type5
• 6 = Type6
The default option is 0 = None.
If the zone does not activate at least once within the programmed criteria a zone masked fault is indicated at
the panel. The fault is logged as a masked event which indicates that the zone has been inactive for the pro-
grammed period. See Option
51.61=Parameters.Activity Monitoring.
9 = Res. Select
This option allows the resistance windows of the zone to be set to a selection of pre-defined values. The zone
resistance windows are:
• Tamper S/C
• Normal/Closed
• High Resistance
• Alarm/Open
• Masked
• Tamper O/C
The values assigned by each of the presets are shown in tables 10 and 11, Parameter 51.46=Res. Select.
10 = Group
NOTE: The Groups attribute is only available if groups have been enabled on the system (refer to option 63
= OPTIONS ).
The Group attribute allows the zone to be assigned to a single group on the system. All zones default to
Group A1 .
On selecting the Group attribute, the group that the zone is currently assigned to is displayed. All zones
default to group A1 . Press the number of the group that the zone is to be reassigned to and press the ent key.
Galaxy 520
The Galaxy 520 panel has 32 groups; these are displayed on the keypad in blocks of eight groups, sub-
divided into A, B, C and D:
Use the A or B key to select the required group ( A1–D8 ). When the end of a block is reached, the next
block of eight groups is displayed; use keys 1–8 to assign the relevant group in the current block to the zone;
press the ent key to accept the selection.
52 - Program Zones (cont’d)