60
Operator’s Manual
Operations
monty 5800
5.9-1
5.9-2
5.0-1
1
5.9 Mounting tractor wheels one
piece rims
1.
Liberally lubricate both beads and the rim.
2.
Firmly fit the mounting clamp to the outer rim flange at
9 o’clock.
Roll the tire onto the footboard and hang it on the
mounting clamp attached to the rim edge.
3.
Place the hook tool as shown in
Fig.5.9-1
.
The edge of the hook should be about 2-3 cm (1") away
radially from the rim edge and 2-3 cm (1") to the outside.
CHECK THAT THE TOOL LOCKING PIN IS NOT
INSERTED (
1,Fig.5.0-1
).
4.
Turn the chuck clockwise until the first bead is mounted.
Remove the clamp.
5.
Place the tube (if any) in the tire and secure the valve
stem to the rim.
6.
Firmly fit the mounting clamp to the outer rim edge at
11 o’clock with valve stem at 10 o’clock in such a way
as to hold the outer bead. If necessary make use of
the tool to create the space to fit the clamp.
7.
Place the hook tool as described in 5.5.2. Rotate the
chuck clockwise till the bead is completely mounted.
If necessary, use the bead bar to keep the bead in the
drop center (
Fig.5.9-2
).
DO NOT INFLATE THE TIRE ON THE MACHINE. THIS
MACHINE IS NOT AN INFLATION DEVICE.
FOR INFLATION PLACE THE WHEEL IN AN
APPROVED INFLATION RESTRAINT DEVICE (IN THE
UNITED STATES OF AMERICA CONSULT O.S.H.A.
REGULATIONS CONCERNING THE PROPER
SERVICING OF TRUCK, WHEELS AND RIMS).
