106
C84
Compensation of unbalance of main shaft
Options
:
None
Special function
:
None
Description:
Compensating for residual unbalance left in the main shaft.
To save balancing of the main shaft by drilling out material or by adding balance weights, the residual unbalance of the
main shaft is determined and compensated for (subtracted) in all subsequent measurement runs.
To compensate for the residual unbalance of the main shaft on a machine without power clamping device carry out the
following steps:
I
MPOTANT! DO NOT USE CONES FROM OTHER BALANCERS MODELS
1. Remove wheel adaptor from main shaft.
2. Activate adjustment function C84.
3. Close the wheel guard and start the measurement run by pressing the
START key
The residual unbalance of the main shaft is determined in an extended measuring run.
Comments:
Complete this calibration with C88 and C90
C84
Compensation of unbalance of main shaft (Power Clamp)
Options
:
None
Special function
:
None
Description:
To save balancing of the main shaft by drilling out material or by adding balance weights, the residual unbalance of the
main shaft is determined and compensated for (subtracted) in all subsequent measurement runs.
Since the angular position of the drive pulley relative to the main shaft is random in the clamped state, the residual
unbalances of main shaft and drive pulley have to be determined and stored separately.
To separate the residual unbalances, two measuring runs have to be performed. Between these measurement runs,
the drive pulley has to be adjusted by approx. 180 degrees relative to the main shaft. To accomplish adjustment of
the drive pulley by 180 degrees, the tie rod must be displaced by another 4 mm in the clamping operation prior to the
second measuring run.
I
MPOTANT! DO NOT USE CONES FROM OTHER BALANCERS MODELS
SM HOF GEODYNA 7600 Rel.D
Summary of Contents for geodyna 7600
Page 1: ...geodyna 7600 Service Manual ...
Page 118: ...118 SM HOF GEODYNA 7600 Rel D ...
