English
13
SELECTING CUTTING ATTACHMENTS
Recommended accessories for each model are presented in the table below.
For purchases, contact Hitachi Authorized Service Centers.
Please check carefully as those accessories not marked with “
●
” cannot be attached.
List of recommended accessories
Type
Name
Speci
fi
cation
LOOP
HANDLE
BIKE
HANDLE
Diameter
Feed System Adapter
or
No. of Teeth (Blade)
Blade Thickness (mm)
or
Trimmer line Diameter
(mm)
CG40EAS (LP)
CG40EAS (P)
ALUMINUM
HEADS
NYLON HEAD
CH-300
(W/CUTTER HOLDER
CAP)
5”
Manual line
feed
2.2 – 2.7
●
●
NYLON HEAD
CH-300
●
●
BLADES
BLADE
B3/10/2.01
10”
3
2.0
●
●
BLADE
B3/12/3.0
12”
3
3.0
●
●
Daily maintenance
○
Clean the exterior of the unit.
○
Check that the harness is undamaged.
○
Check the cutting attachment guard for damage or
cracks. Change the guard in case of impacts or cracks.
○
Check that the cutting attachment is properly centered,
sharp, and without cracks. An o
ff
-center cutting
attachment induces heavy vibrations that may damage
the unit.
○
Check that the cutting attachment nut is su
ffi
ciently
tightened.
○
Make sure that the blade cover is undamaged and that it
can be securely
fi
tted.
○
Check that nuts and screws are su
ffi
ciently tightened.
○
Check that the unit is undamaged and free of defects.
Weekly maintenance
○
Check the starter, especially the cord.
○
Clean the exterior of the spark plug.
○
Remove the spark plug and check the electrode gap.
Adjust it to 0.6 mm, or change the spark plug.
○
Check that the angle gear is
fi
lled with grease up to 3/4.
○
Clean the air
fi
lter.
Monthly maintenance
○
Rinse the fuel tank with gasoline.
○
Clean the exterior of the carburetor and the space
around it.
○
Clean the fan and the space around it.
000Book̲CG40EAS(P).indb 13
000Book̲CG40EAS(P).indb 13
2018/01/05 12:12:36
2018/01/05 12:12:36
