97
Miscellane
ous
Miscellaneous
Draining the water before a move (or to prevent freezing)
If the machine freezes
Close the tap.
Turn on the power, press
to select the
[TUB CLEAN] program, and then press
to start the operation.
Run the operation for about 10 seconds,
press
, and then turn off the power.
z
Running the operation removes the water
from inside the water supply hose.
Disconnect the water supply hose, and
keep it facing down.
(Installation Instructions P. 21)
z
Place a bucket or rag underneath the water
supply hose, as water may drip out.
Disconnect the water supply hose.
Pour about 5 L of warm water (about
40°C) into the drum, and let it sit for
about 10 minutes.
Connect the water supply hose, and
open the tap.
Open
Insert the drain hose into the drain outlet.
Turn on the power, press the [SPIN]
button to set spin only, press
, and
run the operation for about 30 seconds.
(P. 56)
z
This will remove the water from the drum and
drain hose.
Press
, and then turn off the power.
Turn on the power, press the [START]
button, and let the machine sit.
This will thaw the water supply valve.
z
The heat from the machine will thaw the
water supply valve, and water supply will start
(after about 20 minutes).
Verify the following:
(1) Check whether you can rotate the drum with
your hands.
Verify rotation
(2) Turn on the power, press the [SPIN] button to
set spin only
(P. 56)
, start the operation, and
check whether water drains.
Verify drainage
Ú
If the above are not possible, repeat steps
to .
If freezing is a concern when using the machine in a
cold environment, place a blanket, for example, on top
of the machine and cover the rear to keep the machine
warm.
Blanket
En
g
lish
Summary of Contents for BD-W3500
Page 198: ...198 ýĔüúęâ ...