Hitachi BD-W3500, Operating Instructions Manual, Page: 86 / 200

86
Symptom
Possible cause Solution
[S
T
A
R
T
] b
u
tt
o
n
Operations do not
start even when
the [START] button
is pressed.
Is the DELAY START function set?
If you want to start the operation immediately,
cancel the delay.
(P. 58)
The water drains
when the [START]
button is pressed.
z
If the drum is full (about 29 L) when you start
an operation, it will be drained before the
operation starts.
This is not a malfunction.
Det
er
gent
dispenser
Water remains
in the detergent
dispenser.
z
As liquid detergent and softener are added by
injecting water and creating a siphon effect,
water may remain in the detergent dispenser in
some cases.
If this is a concern, empty the water or wipe it off,
or clean the dispenser.
(P. 75)
Are the caps attached? Make sure the caps are attached securely.
Is the machine installation level? (Installation
Instructions)
z
If the machine is not level, the siphon effect
will not occur and the water in the detergent
dispenser will not drain properly.
Make sure the air bubble in the spirit level is inside
the circle.
Dr
y
fi
lt
er
The dry filter is
wet.
Did you stop an operation while it was in
progress?
z
If you stop a drying operation before the
laundry is completely dry, the dry filter may be
wet. This is not a malfunction.
Is the dry filter clogged?
z
If so, the dry filter may get wet.
Clean the dry filter. (P. 73, 74)
z
If you leave the dry filter in a wet state, mold
growth may occur.
Remove the dry filter, and allow it to dry naturally.
Dust does not
accumulate in the
dry filter.
Did you set the dehumidification mode during
drying operations to Water Cooling Mode?
z
When the Water Cooling Mode is used, dust
is discharged together with the water used
for cooling dehumidification and may not
accumulate in the dry filter significantly.
This is not a malfunction.
S
o
u
n
d g
u
id
e
s a
n
d wa
rn
in
g
s
The operation
start/finish sounds
and pre-finish
sounds are not
emitted.
Did you disable the operation start/finish
sounds and pre-finish sounds?
Set the operation start/finish sound to the melody
or buzzer setting.
(P. 64)
Enable the pre-finish warning sound setting.
(P. 64)
The operation
start/finish sounds
and pre-finish
sounds are barely
audible.
z
Audibility may vary depending on the ambient
noise and machine operation noise. The volume of the operation start/finish sounds
and pre-finish sounds cannot be adjusted.
Troubleshooting
(continued)