Hitachi BD-W3500, Operating Instructions Manual, Page: 80 / 200

80
Indicator and meaning Possible cause and solution
Drying is not complete, even
after 6 hours of drying.
Press
to turn off
the power.
z
Check whether there is lint in dry filter or dry filter
port.
If it is clogged, perform maintenance. (P. 73, 74)
z
Make sure the laundry has been spun and is not
tangled.
z
Make sure water is being properly supplied. (Water is
used for cooling operations during drying.)
Refer to the solution for when “C01” is displayed.
z
Make sure the drain hose is installed properly.
Refer to the solution for when “C02” is displayed.
z
This appears after every 25 times the [WASH DRY]
and [DRY] operations are used (even if lint buildup is
low).
Press
to start the
operation.
The door cannot be locked or
unlocked.
Press
to pause.
z
Close the door completely.
z
Make sure the laundry load is not too large.
Press
to start the
operation.
The lint filter is not inserted
properly.
z
Insert the lint filter properly.
Turn the lint filter knob clockwise until it clicks into
place. (P. 71, 72)
Press
to start the
operation.
The lint filter is clogged.
Press
to turn off
the power.
z
Check whether the lint filter is clogged.
If it is clogged, perform maintenance. (P. 71, 72)
z
This appears after the [WASH] and [WASH DRY]
operations are used (even if lint buildup is low).
Press
to start the
operation.
Spinning is not possible.
Press
to pause.
z
Make sure the drain hose is installed properly.
Refer to the solution for when “C02” is displayed.
(P. 79)
z
Check whether there is excessive foaming.
Run a rinse operation before trying to spin again.
(P. 55)
Press
to start the
operation.
The drying load is too large.
Press
to pause.
z
Check the size of your laundry load.
Reduce the number of items.
The amount of laundry that can be dried depends
on the size and type of the items.
Press
to start the
operation.
The drum cannot rotate.
Press
to pause.
z
Check the size of your laundry load.
Reduce the number of items.
z
Check whether the laundry is tangled.
Untangle the laundry.
z
Check whether there is excessive foaming.
Run a rinse operation before trying to spin again.
(P. 55)
z
Do not use an extension cord to connect the power
plug.
z
Do not connect other appliances to the same power
outlet as the machine.
Press
to start the
operation.
The dry filter is clogged.
Press to
turn off the
power.
z
Check whether there is lint in dry filter or dry filter
port.
If it is clogged, perform maintenance. (P. 73, 74)
(The [DRY FILTER] indicator may light again, even
after you clean the dry filter and turn the power on.
In such cases, press [START] to turn it off.)
z
This appears after every 25 times the [WASH DRY]
and [DRY] operations are used (even if lint buildup is
low).
Press
to start the
operation.
If the following occurs, stop operations and contact a service representative.
z
If the “CXX” indication persists even after performing the above solutions.
z
If an “FXX” or “CXX” indication not described above persists even after turning the power off and turning it on
again.