79
T
rouble
shooting
Indicator and meaning
Possible cause and solution
Water cannot be supplied.
Press
to pause.
z
Make sure the tap is open.
z
Make sure the water supply inlet’s filter is not
clogged.
(P. 77)
z
Check whether a water outage has occurred.
z
Make sure the water supply pipe or water supply
hose is not frozen.
(P. 97)
Press
to start the
operation.
Water cannot be drained.
Press
to pause.
z
Make sure the drain hose or drain outlet is not
clogged with lint or other debris.
(P. 78)
z
Make sure the drain hose is installed properly.
(Installation Instructions)
• Make sure it is not pinched or frozen.
• Make sure it is laying flat.
• Make sure the end of the hose is not submerged in
water.
• Make sure it does not rise 10 cm or more above the
ground at any point.
z
When using an extension hose, make sure the hose
does not exceed 2 m in length.
Press
to start the
operation
The door is open.
Press
to pause.
z
Close the door.
For safety, the door is locked during operations.
z
Make sure the door stopper is retracted.
Use a coin or similar object to turn the door stopper
counterclockwise until it clicks into place.
Press
to start the
operation.
Spinning is not possible.
Press
to pause.
z
Make sure the laundry is not concentrated on one
side.
Distribute the laundry in the drum as evenly as
possible. (Even if it appears even, items made of
cotton, for example, can become heavy with water,
causing imbalance if concentrated in one area.)
z
Do not wash thick items (cotton blankets, jeans, etc.)
or items in mesh laundry bags alone.
Add 2 or 3 more items, and wash together. (Single
pieces of laundry tend to gravitate to one side.)
(P. 18 to 21)
z
Do not wash too many sheets or large items at one
time.
Reduce the number of large items.
(P. 18 to 21)
z
Make sure the machine is stable and installed on a
level surface.
Make sure the air bubble in the spirit level is inside
the circle. (Installation Instructions)
z
Do not load items that cannot be washed or dried.
Remove items that cannot be washed or dried.
(P. 16)
Such items can increase the vibration during the
spin cycle.
Press
to start the
operation.
Troubleshooting
Error codes in the remaining time indicator
Note on Auto
Power Off
z
If you turn the power on and do not start an operation within 10 minutes, the power will turn
off automatically.
z
If the machine remains in the pause state for more than 1 hour, the power will turn off
automatically.
z
The power turns off automatically after an operation finishes.
z
If the error code is left displayed for more than 12 hours, the power turns off automatically.
z
In the following cases, the indicator will blink and a buzzer will be emitted.
Press [PAUSE] or [OFF] to stop the operation, and then press [START] or [ON] to restart the operation.
If the error code continues to appear, check the “Solution” column below.
Ú
For details on displays not described below, see
(P. 91, 92)
.
En
g
lish
Summary of Contents for BD-W3500
Page 198: ...198 ýĔüúęâ ...
