Hioki 2300 Smart Site, Instruction Manual, Page: 288 / 366

16 2354-20 MEMORY MODULE
275
1
2
3
4
5
16
7
8
9
APPX
IDX
*1 Refer to
16.4.2 "Recording operation"(P.283)
for recording indications and
operational methods.
*2 Refer to
16.4.1 "For CF card"(P.280)
for CF card indications and opera-
tional methods.
*
3 The module needs repair. Contact your dealer or Hioki representative.
*4 The cause of an error may be the connection of two or more commu-
nication modules.
POWER LED Goes on or flashes when power is supplied to the module.
Remains on, flashes, or changes to another color according to the state of
the module.
Lit in green
: Operating normally
Lit in red : Non-recoverable error occurred.
*3
Flashing in red : Recoverable error occurred.
*4
CF CARD LED Colors of the lights, flashing lights vary depending on the condition of the
CF card: *
2
REC LED Colors of the lights, flashing lights vary depending on the recording condi-
tion of the instrument: *
1
START/STOP switch Starting and ending the recording
Recording will start when the button is pressed for more than 2 seconds
during recording stop. Recording will stop when the button is pressed for
more than 2 seconds during recording.
100BASE-TX terminal
LINK LED
Rx/Tx LED The 9642 LAN cable connects the terminal and a PC.
LED lights and flashes vary according to the conditions of the LAN connec-
tion and communications.
LINK LED unlit
: LAN cable is not connected properly or the
PC is not switched on
LINK LED lit in yellow : linking (LAN cable is connected properly)
Rx/Tx LED flashing in green: Data transmission
Mark area Use this area to make a note of the object to measure or the com ID.
Use an ink pen, since pencil lead may rub off.
Cover Open the cover and insert/ remove the CF card.
Close the cover firmly after inserting the CF card.
CFcard slot Slot for inserting the CF card.
Slide the CF card all the way in.
Eject button Press to eject the CF card.
COM ID setting dial Use the dial to set the module's identification No.
When power is switched or when the power is cut off, the POWER LED will
flash in orange. When the orange light is flashing, do not operate the
instrument. The instrument is preparing to start up or shut down. If the
instrument is handled during this time, data saved in the CF card may be
corrupted. In addition, if the yellow light still flashes 20 seconds after power
has been turned on, check the end terminals of the module base’s CAN
switch (TERMINATION ON/OFF). Refer to 19 "2391-01, 2391-02, 2391-03
MODULE BASE"(P.305) and
20 "2392-01/02 MODULE BASE"(P.319) for
details on end terminal switch.