Hioki 2300 Smart Site, Instruction Manual, Page: 185 / 366

172
9 2331-20 POWER METER MODULE
Clamp Sensors:
9695-02 (50 A), 9695-03 (100 A), 9661-01 (500 A), 9765 (5 A, For
CT secondary side)
Terminals
M3.0 screws are used for the terminal blocks for this module and
the clamp sensors. For connection, a round crimp connector (RAV
1.25-3) is recommended.
Cables
The 9695-02 and 9695-03 use terminal blocks. Therefore, various
types of cables may be usable.
Cables equivalent to or better than 600 V vinyl-insulated 0.9 mm
2
or 300 V vinyl-insulated 0.75 mm
2
are recommended.
The 9238 CLAMP SENSOR CABLE (3 m) is optionally available.
9.3.3 Connecting the Voltage Cable to the Module
1.
Use the U RANGE switch to select 100 V (70 to 130 VAC) or
200 V (140 to 260 VAC).
2.
Connect voltage cables to the U INPUT terminals (at a tight-
ening torque of 0.8 N•m).
❖
"Connection diagram"(P.176)
The terminal blocks use M3.5 screws. For connection, a round
crimp connector (RAV 1.25-3.5) is recommended.
For wiring, cables equivalent to or better than 600 V vinyl-insulated
0.9 mm
2
is recommened.
Note that measurement may be adversely affected by external
noise or the electromagnetic environment when using cable
longer than 3 meters.