Hill-Rom CareAssist P1170, Service Manual

Page: 85 / 197

4.1 Sleep Deck
Chapter 4: Removal, Replacement, and Adjustment Procedures
CareAssist™ Bed Service Manual (man330) Page 4 - 5
4
d. Remove the screw (E) securing the CPR handle (F) to the CPR mount
bracket (I).
e. Remove the CPR handle (F) from the CPR cable (G).
f. Loosen, do not remove, the jam nut (H) securing the CPR cable (G) to
the CPR mount bracket (I).
g. Remove the two screws (J) securing the cable guide (K) to the head
section (D).
h. Remove the cable guide (K) from the CPR cable (G).
i. Repeat step d through step h for the other side.
j. Remove the E-ring (L) from one side of the lower hinge point (M).
k. Remove the plastic washer (N) from the lower hinge point (M).
l. Repeat step j and step k for the other side.
m. Move the head section to one side to disengage the hinge bracket (O)
from the hinge point (M).
n. Move the head section to the other side to disengage the hinge bracket
(O) from the hinge point (M).
o. Slide the head section (D) toward the head end of the bed to disengage
it from the head section frame.
p. Remove the head section (D) from the bed.
Replacement
1. Do the removal procedure in reverse order.
NOTE:
The seat section can only be installed when the head section is in the full up
position.
2. Make sure the CPR cable is adjusted correctly (refer to procedure 4.6)
3. To make sure the CareAssist™ Bed operates correctly, do the “Function
Checks” on page 2-6.