Hill-Rom CareAssist P1170, Service Manual

Page: 52 / 197

2.1 No Functions Work
Chapter 2: Troubleshooting Procedures
Page 2 - 10 CareAssist™ Bed Service Manual (man330)
2.1 No Functions Work
NOTE:
This procedure assumes that no functions work from the pendant or caregiver
controls on the siderails.
SHOCK HAZARD:
The potential for electrical shock exists with electrical equipment.
Failure to follow facility protocols may result in death or serious
personal injury.
1. Verify the two AC power fuses and one interface P.C. board in-line cable
fuse are serviceable.
The fuses are serviceable.
Yes No
↓ →
Replace the fuses (refer to procedure 4.16), and then go to
“Function Checks” on page 2-4.
2. Verify all the cables on the AC power P.C. board and motor control P.C.
board are connected correctly.
All cables connected properly.
Yes No
↓ →
Connect the cables as required, and then go to “Function
Checks” on page 2-4.
3. Make sure the AC power cable operates correctly.
The cable is plugged into the power outlet correctly.
Yes No
↓ →
Plug the cable into the outlet correctly, and then go to “Function
Checks” on page 2-4.
4. Unplug the bed from its power source and use an appropriate test device to
check for the presence of the voltage at the power outlet.
The voltage is correct.
Yes No
↓ →
Inform the customer of the problem concerning the power outlet.
Connect the bed to a working power outlet, and then go to
“Function Checks” on page 2-4.
5. Examine the AC power cable for damage.
The AC power cable is in satisfactory condition.