Hill-Rom CareAssist P1170, Service Manual

Page: 123 / 197

4.14 SideCom® Communication System P.C. Board
Chapter 4: Removal, Replacement, and Adjustment Procedures
CareAssist™ Bed Service Manual (man330) Page 4 - 43
4
4.14 SideCom® Communication System P.C. Board
Tools required: T15 Torx®
1
screwdriver
T25 Torx® screwdriver
Removal
1. Set the brakes.
2. Raise the unit to its highest position.
SHOCK HAZARD:
Unplug the unit from its power source. Failure to do so could result in
personal injury or equipment damage.
3. Unplug the unit from its power source. Let the unit to sit for 60 seconds for
the battery to time out.
NOTE:
The SideCom® Communication System P.C. board is mounted on the
interface box cover.
4. Remove the nine screws (A) securing the interface box cover (B) to the
interface box (C) (see figure 4-19 on page 4-44).
5. Lower the box cover (B).
6. Disconnect all cables from the SideCom® Communication System P.C.
board (D) and interface P.C. board (E).
7. Remove the six screws (F) securing the interface P.C. board (E) to the box
cover (B).
8. Remove the five screws (G) securing the SideCom® Communication
System P.C. board (D) to the box cover (B).
9. Remove the SideCom® Communication System P.C. board (D).
1. Torx® is a registered trademark of Textron, Inc.