Hill-Rom CareAssist P1170, Service Manual

Page: 176 / 197

Preventive Maintenance
Chapter 6: General Procedures
Page 6 - 6 CareAssist™ Bed Service Manual (man330)
Hilow columns Inspect the column assembly for the presence and tightness of the
attachment screws and the snap ring at the bottom of the column.
Repair as necessary.
Fully raise and lower the bed frame one time.
Make sure there is no friction or abnormal noises and that no audible
overload indication can be heard during the movement.
Make sure the Bed Not Down position indicator illuminates on the
control pendant and goes out when the bed is in the low position.
Replace the defective column(s) in the event of a malfunction.
Troubleshoot in the event of a doubt.
Head section motor Inspect the actuator assembly. Make sure the pins and retaining clips
are intact and not missing.
Fully raise and lower the head section. Make sure there is no friction
or abnormal noises and that no audible overload indication can be
heard during the movement.
Repair as necessary.
Plastic sleep deck Fully raise and lower the head section.
Check for binding during the head section movement.
Make sure the hard surface and its drive system are in good
condition.
Make sure there is no friction or abnormal noises.
Replace any damaged parts.
Remove each hard surface (except the head section) and check its
condition.
Replace if necessary.
Function Procedure