HIKVISION DS-6700HFHI/V Series, User Manual, Page: 54 / 76

DS-6700HFHI/V Series Network HD Encoder User Manual
53
Figure 7. 15 Video Tampering Alarm Settings
3. Click checkbox of Enable Video Tampering .
4. Set the video tampering detection area. Please refer to Step 1 Set the Motion Detection Area in Chapter
8.3.1.
5. Configure the arming schedule for video tampering detection. The arming schedule configuration is the
same as the Setting of the Arming Schedule for Motion Detection. Please refer to Step 2 Set the Arming Schedule
for Motion Detection in Section Configuring Motion Detection.
6. Click the Linkage Method tab to set the actions taken for the tamper-proof alarm. Please refer to Step 3 Set
the Alarm Actions Taken for Motion Detection in Section Configuring Motion Detection .
7.7.5 Handling Exception
The exception type can be HDD full, HDD error, network disconnected, IP address conflict, illegal access, video
standard mismatch, video signal exception, record exception and video resolution mismatch.
When the selected resolution under Configuration > Video/Audio and the actual video input resolution are
mismatched, the exception alarm will occur. Please refer to Section Configuring Video Settings.
Steps:
1. Click Configuration> Event > Basic Event > Exception to enter the Exception Settings interface.
2. Check the checkbox to set the actions taken for the Exception alarm. Please refer to Step 3 Set the Alarm
Actions Taken for Motion Detection in Section Configuring Motion Detection .