DS-6700HFHI/V Series Network HD Encoder User Manual
35
depending on the location of the e-mail accounts to which you want to send notification.
2.
Please configure the DNS Server settings under
Configuration >
Network > Basic Settings > TCP/IP
before using the Email function.
Steps:
1.
Enter the
Basic Network Settings
(
Configuration >
Network > Basic Settings > TCP/IP)
to set the IPv4
Address, IPv4 Subnet Mask, IPv4 Default Gateway and the Preferred DNS Server.
2.
Click the
Configuration >
Network > Advanced Settings > Email
to enter the Email settings interface:
Figure 6. 18
Email Settings
3.
Configure the following Email settings:
Sender:
The name of sender.
Sender’s Address:
The
Email address of sender.
SMTP Server:
The SMTP Server IP address or host name (e.g., smtp.263xmail.com).
SMTP Port:
The SMTP port. The default TCP/IP port used for SMTP is 25.
Enable SSL (optional):
Click the checkbox to enable SSL if required by the SMTP server. When the
SSL is enabled, the default TCP/IP port used for SMTP is 465.
Attached Image(optional):
Check the checkbox of Attached Image if you want to send email with
attached alarm images. Set the interval between two actions of sending attached pictures.
Authentication
(optional): If your mail server requires authentication, check this checkbox to use
authentication to log in to this server and enter the login User Name and Password.
Receiver:
The name of user to be notified. Up to 3 receivers can be configured.
Receiver’s Address:
The Email address of user to be notified.
4.
Click
Save
to save the Email settings.
Please refer to the following sections for more information:
Configure alarm linking methods with
Send Email
on
Section Configuring Motion Detection
Section
Configuring External Alarm Input, Section Configuring Video Loss Alarm, Section Configuring Video Tampering
and
Section Handling Exception.