17
Enforcer V10 Programming Guide
Endstation Outputs
This function programs the Bell, Strobe and PGM output on the I/O board if connected.
ZEM Outputs
If a zone expander with additional outputs has been connected to the Enforcer, this function programs the outputs
on each expander. The address of the expander is required before the output programming.
Wireless Bells
At default, any wireless bells learnt to the Enforcer have the two outputs programmed as ‘Siren Any’ and ‘Strobe Any’.
These outputs can be programmed differently if required.
Output Module Outputs
If an output expander is connected to the Enforcer, it must be addressed in this function. All output programming
is also done here. A maximum of 1 output expander can be connected to the Enforcer.
Change Output Programming
1.
Press
or
to scroll to ‘CHANGE OUTPUTS’. Press
.
2.
‘Endstation Outputs’ will be displayed. Press
to program any outputs on
the I/O module, or press
for the next function. Use
[
or
]
to scroll
through the outputs or the select the shortcut number.
3.
‘ZEM Outputs’ will be displayed. Press
to program any outputs on the
zone expander, or press
for the next function.
4.
‘Wireless Bells’’ will be displayed. Press
to program any wireless output
types or press
for the next function.
5.
‘Output Module Outputs’’ will be displayed. Press
to address an output
module or press
for the next function.
6.
‘Keypad Outputs’ will be displayed. Press
to program any outputs on any
additional keypads connected or press
for the next function.
7.
‘Reader Outputs’ will be displayed. Press
to program any outputs on any
readers connected or press
for the next function.
8.
‘User Outputs’ will be displayed. User Outputs can be activated from the
Master Manager Menu, and can also be programmed to be operated via a
keyfob. If required, this is programmed in ‘Program Keyfob Buttons’ , sub-menu
‘WIRELESS DEVICE CONTROL’ and program a button(s) for types 170-199.
ASSIGN KEYPADS/READERS
Any additional keypads or readers must be addressed correctly before enabling them in this function. The Enforcer
keypad is automatically addressed as 0 on initial power up. Refer to installation manual for more information.
Address
Up to 3 additional wired keypads or readers and 4 wireless arming stations can also be installed. Address 0 is used
for the Enforcer on-board keypad.
