51
Enforcer V10 Programming Guide
NO.
TYPE
ACTIVE
RESTORE
0014
Siren Any
When alarm live
When alarm silenced or when
siren timer expires
0016
Strobe Any
When alarm live
When alarm silenced or when
strobe timer expires
0017
Omit Rearm Any
Input omitted if active (or in
alarm condition) at the end of
confirmation time.
When system disarmed
0018
Unconfirmed Any
Any intruder or Tamper alarm
At code entry to silence
0021
Exit Starts Any
When exit time starts to set FIRST
area
At code entry to unset LAST area
0022
Final Set Any
When FIRST area is set
At code entry to unset LAST area
0023
Strobe Set Fail
Works similar to output 016, but also fires if the set fail timer expires.
0025
Keyswitch unset
This output turns on for 5 seconds when the system is disarmed via a
keyswitch input (pulsed or latched)
0026
Set with Omit
Activates when inputs are omitted on setting
0028
Power Fault
Active during low volts and battery faults*. Restores at code entry
after fault cleared.
0029
Confirmed Intruder Any
When more than one intruder
alarm activates
At next code entry
0030
Confirmed Hold Up Any
When more than one confirmed
hold up activates
At next code entry
0033
Entry/Exit
Live during any entry or exit time
0034
Lights
When exit or entry timer starts
20 seconds after set/unset
procedure completed
0035
Follow Input
When input triggers
Dependent upon programming
0037
Restore 1
At code entry to set
After 3 seconds
0038
Restore 2
At code entry to set
When unset
0039
PIR Latch 1
When set (and in Walk Test)
At alarm, or when unset
0040
PIR Latch 2
This is the inverse polarity to PIR Latch 1
0041
Mains Good
Output showing the mains is healthy
0042
Detr Indn Enable
This output activates during walk test and also when a code is
entered to view indications – staying activated for the time for which
the indications are viewed.
0043
Follow Test
New output for alternative bell test by activating SAB
0044
Off During Test
New output for alternative bell test by activating SAB
0048
Detr Walk Test
This output is active during walk test, and will only deactivate when
all detectors have been tested.
0049
Detector Masked
(Not applicable on
grade 2 systems)"
If any detector goes into ‘mask’
condition the output will trigger
When masking fault clears.
0050
Follow 24 Hour
If any input programmed as “Day
alarm” activates
When input restored
