9
Enforcer V10 Programming Guide
1.
Press
2.
Enter the Engineer code (default 1111).
3.
Press
if any faults appear.
4.
‘SET SYSTEM’ is displayed.
5.
Press
6.
‘FORCE ARM ON 1st INPUT’ is displayed.
7.
Enter the 1st input that is to be active. Press
8.
Enter the 2nd input that is to be active. Press
9.
Select the areas to set. Press
10. The setting period will begin
11. Once the timer expires, and a beep is heard, the Enforcer is set and the 2
inputs chosen will be active.
12. To unset, enter the Engineer code again.
THE ENGINEER MENU
Any programming is only saved when exiting the Engineer menu. It is essential that a ‘CLEAN START’ is performed
after initial power up.
SET DATE & TIME
All log entries are date and time stamped. This can also programmed in the Master Manager Mode. The time is also
shown on the LCD in ‘Day Mode’ .
Please note: Please note that powering down the system will reset the time and date information.
Year, Month, Day, Hours, and Minutes
Enter the year, month, day, hours and minutes.
DST Adjust
Enable or disable the ‘Day Light Saver Time Adjust’ as required.
Set Date and Time Programming
Press
or
to scroll to ‘SET DATE AND TIME’. Press
.
‘Year’ will be displayed. Enter the year and press
. Repeat for Month, Day, Hours
and Minutes and press
.
‘DST Adjust’ will be displayed. Press
[
or
]
to enable or disable the function
and press
.
