en
Rev. 03 / 02.2021
AB3200
44 / 88
Software description
5 20 9/;\9 1500 2:00
PROG
T/°C
RCF
RPM
t/min
Changing settings during the
centrifugation run
1 20 9/;\9 1500 2:00
PROG
T/°C
RCF
RPM
t/min
RCL 1
PROG
T/°C
RCF
RPM
t/min
RCL 5
PROG
T/°C
RCF
RPM
t/min
Program recall..
PROG
T/°C
RCF
RPM
t/min
5 20 9/;\9 1500 2:00
PROG
T/°C
RCF
RPM
t/min
1 20 9/;\9 1500 2:00
PROG
T/°C
RCF
RPM
t/min
4.
Set
‘+’ or ‘-’ using the [adjusting knob].
‘+’
Program is write-protected
‘-’
Program is not write-protected.
5.
Press the
[START] key to save the setting.
It is not possible to change the settings during the centrifu-
gation run if program links are used.
The runtime, speed, relative centrifugal force (RCF), the
start-up and run-down parameters as well as the tempera-
ture (only for device with cooling) can be changed during
the centrifugation run.
Change the value of the desired parameter
parameters’ on page 47: The changed setting is stored at program loca-
tion
‘Automatic buffer’ on page 43. The original program is not over-
written. The program location number is displayed in parentheses
‘( )’. This
means that the centrifugation data on the display no longer agrees with the
stored centrifugation data of the program location.
7.1.1
Calling up/loading program (RCL 1-99)
To call up (load) a program, proceed as follows:
1.
Press the
[PROG] key.
2.
Use the
[adjusting knob] to set the desired program location.
If a ‘+’ is displayed after the program location, the
data is write-protected.
In this case, the write protection has be removed first
before saving is possible
3.
Press the
[START] key.
4.
You can now run the loaded program with the lid closed with the
[START] key.
7.1.2
Save programs (STO 1-99)
The previous program location data will be overwritten
when the new data is saved. If ‘Protected !!’ is displayed,
the data at the program location is write-protected and will
not be saved.
To save new programs, proceed as follows:
