Hettich ZENTRIMIX 380 R, Operating Manual

Page: 63 / 88

63 / 88 en Rev. 03 / 02.2021 AB3200
Software description
Start program
-] Settings
PROG T/°C RCF RPM t/min
Start program = First
PROG T/°C RCF RPM t/min
Store Settings...
PROG T/°C RCF RPM t/min
-] Settings
PROG T/°C RCF
RPM
t/min
Temp Unit = Celsius
PROG T/°C RCF
RPM
t/min
Store Settings...
PROG T/°C RCF
RPM
t/min
7.3.5.3 Start program
After switching on, the centrifugation data of program 1 or
the last used program/program link is displayed.
To set what centrifugation data is to be displayed at switch-on, proceed as
follows:
1. Change to the menu
‘Machine Menu
🠂
Settings’
⮫
Chapter 7.3
‘Machine Menu’ on page 55.
2. Press the
[PROG] key until the ‘Start program’ parameter is displayed.
3. Set
‘First’ or ‘Last’ using the [adjusting knob].
‘First’
Program at storage space 1 / program link
at storage space A.
‘Last’
Last used program/program link.
4. Press the
[START] key to save the setting.
5.
[STOP/OPEN] key Press 1x ⇒
Back to the menu
‘Machine Menu’.
6.
[STOP/OPEN] key Press 1x ⇒
Back to the main display
7.3.5.4 Temp Unit
Please observe the notice
⮫
Further information on page 55
The temperature can be input in degrees Celsius (°C) or
degrees Fahrenheit (°F).
Set the unit of temperature as follows:
1. Change to the menu ‘Machine Menu
🠂
Settings’
⮫
Further informa-
tion on page 55.
2. Press the [PROG] key until the ‘Temp Unit’ parameter is displayed.
3. Set ‘Celsius’ or ‘Fahrenheit’ using the [adjusting knob].
4. Press the [START] key to save the setting.
5. [STOP/OPEN] key Press 1x
⇒
Back to the menu ‘Machine Menu’.
6. [STOP/OPEN] key Press 1x
⇒
Back to the main display