en
Rev. 03 / 02.2021
AB3200
46 / 88
Software description
1 20 9/;\9 1500 2:00
PROG
T/°C
RCF
RPM
t/min
EDIT A
PROG
T/°C
RCF
RPM
t/min
EDIT A
PROG
T/°C
RCF
RPM
t/min
EDIT A.01 = 01
PROG
T/°C
RCF
RPM
t/min
EDIT A.01 = 03
PROG
T/°C
RCF
RPM
t/min
EDIT A.02 = 01
PROG
T/°C
RCF
RPM
t/min
EDIT A.02 = 05
PROG
T/°C
RCF
RPM
t/min
EDIT A.03 = END
PROG
T/°C
RCF
RPM
t/min
STO A
PROG
T/°C
RCF
RPM
t/min
STO A
PROG
T/°C
RCF
RPM
t/min
Multi program store..
PROG
T/°C
RCF
RPM
t/min
A 19 9/;\9 > 63< 2:00
PROG
T/°C
RCF
RPM
t/min
7.1.4
Editing a program link (EDIT A-Z)
It is possible to save 25 program linkages (program loca-
tions A to Z; there is no program location J). A program
linkage can consist of no more than 20 programs.
The speed adjustment from one program to the next one is
always done in a program linkage with the start-up param-
eter of the next program.
No continuous run programs or programs with start-up and
run-down times (parameters
_/
t and
^\
t) can be linked.
No centrifugation parameters can be changed in a program
link. A parameter modification is only possible in the indi-
vidual programs.
The total runtime of the program link and the runtime of the
currently running program can be called up during the cen-
trifugation run with the [TIME] key.
To create or change a program link, proceed as follows:
1.
Press the
[PROG] key until ‘EDIT A’ is displayed.
2.
Use the
[adjusting knob] to set the desired program location.
3.
Press the
[START] key.
4.
Set the first program for the program link with the
[adjusting knob].
5.
Press the
[PROG] key.
6.
Set the next program for the program link with the
[adjusting knob].
7.
Press the
[PROG] key.
8.
Repeat the previous steps until all desired programs are linked.
After the last program, add a program with ‘END’.
For program linkages which consist of 20 programs,
program, ‘END’ cannot be set after the 20th Program
and can be omitted in this case.
9.
Press the
[START] key.
10. Use the
[adjusting knob] to set the desired program location.
11. Press the
[START] key.
12. You can now run the loaded program link with the lid closed with the
[START] key.
