43 / 88
en
Rev. 03 / 02.2021
AB3200
Software description
Fig. 24: Programs and program
links
Automatic buffer
Write protection for programs
1 20 9/;\9 1500 2:00
PROG
T/°C
RCF
RPM
t/min
5 20 9/;\9 1500 2:00
PROG
T/°C
RCF
RPM
t/min
RCL 5
PROG
T/°C
RCF
RPM
t/min
Set Protection = 5+
PROG
T/°C
RCF
RPM
t/min
If parameters are changed, the program location number is
displayed in parentheses ‘( )’. This means that the centrifu-
gation data on the display no longer agrees with the stored
centrifugation data of the program location.
* The display of program links is only possible if the ‘Multi
programs’ function is activated in the ‘Settings’.
RCL: Recall Program - Call up program or program link
STO: Store Program - Save the program or program link
EDIT: Edit Program - Edit program link
1-99: Progam
A-Z: Program linkage
Program location
‘0’ acts as a buffer for the centrifugation data of the last
centrifugation run.
No programs can be stored at this program location. After every start of a
centrifugation run, the centrifugation data used for the run is automatically
stored at program location
‘0’ and can be called up.
The programs can be protected against unintentional modi-
fication.
The write protection can be activated/deactivated as follows when the rotor
is at a standstill:
1.
Call up the program for which you would like to activate/deactivate
write protection
Chapter 7.1.1 ‘Calling up/loading program (RCL
2.
Press the
[PROG] key.
3.
Keep the
[PROG] pressed for 8 seconds.
