HappyJapan HCR3E Series, Instruction Book

Page: 175 / 330

-3A -75
15-1a
MACHINE SETTINGS
15_1a V208
No. Display Settings
(std : Underlined or Blue)
Contents
9 Cut at null jump This sets thread cuts before null jumps (Jump without moving)
YES : Does trim on empty jump data.
Auto thread cut
Null jump
Stitch
Stitch
10 CHG. always cut Forces a trim at every color change.
YES : Always thread trim before color change.
Jump
Jump
Jump
Color change
or Sop
Auto thread cut
NO : If data does not have trim function at color change point,
machine does not trim.
Jump
Jump
Jump
Color change
or Sop
11 Length of TRD. cut
Min.
Short
Normal
Long
Max.
Needle........
The machine cuts upper threads to a longer length.
• The upper threads of each needle will be cut off by registered
length. 15-3
12 Slow
(mend out)
When mending finishes and all heads start to embroider again,
machine speed to be decelerated for safety purpose. 9-7b
13 Width data all
-1.0 ~ 0.0 ~1.0mm
This is to alter the widths of all satin stitches for all the designs in the
memory.
Adjust satin stitch width by selected amount. 15-3a
L
L + Xmm
Satin stitch width by selected
Widths of satin stitches for the designs
in the memory
14 TRD. break detect
Off ~ Slow 3~
Norma ~ Quick 3 ~
Needle........
Sensitivity selection of the thread break detect sensor.
Select "Quick" to increase sensitivity.
Select "Slow" to decrease sensitivity.
By default it is set to "Normal".
• You can set sensitivity of thread break detection needle by needle.
15-4