HappyJapan HCR3E Series, Instruction Book

Page: 221 / 330

-3A -90
18-8
OTHER SETTINGS
User maintenance mode
User maintenance mode has 8 items as below.
Indicates point which sensors are active.
22_5 N101
Conditions
L point sensor The point that indicator becomes RED is L-point, when upper shaft is turned.
C point sensor The point that indicator becomes RED is C-point, when upper shaft is turned.
Needle sensor The point that indicator becomes RED is needle position, when moving head is
moved.
Origin point of cutter The point that indicator becomes RED is origin point of cutter.
Origin point of thread catcher The point that indicator becomes RED is origin point of thread catcher.
Angle
Indicate angle of upper shaft.
In addition, directly enter the angle when you press
, the upper shaft can be turned to any
angle.
Please use dial when you need to know precision angle.
Key Machine movement
Change jumps
Change the needle bar’s movement.
“JUMP” : Needle Jump, “DRIVE” : Needle Drive
Upper shaft turns
Upper shaft turns clockwise and counterclockwise.
When release key, upper shaft stops.
Caution: please be careful that Needles for all head move at once.
Needle change
Move the sewing head to the adjustment needle in the direction of
the arrows.
Cutter Open/Close
When cutter is open position, cutter move to close position.
When cutter is close position, cutter move to open position.
Caution: please be careful that cutter for all head move at once.
Cutter Open/Close
When catcher is open position, cutter move to close position.
When catcher is close position, cutter move to open position.
Clip-type thread holder (option)
When clip is open position, clip move to close position.
When clip is close position, clip move to open position
.
Keeper
When keeper is open position, keeper move to close position.
When keeper is close position, keeper move to open position.
Standby position
In case, each equipment position without standby position, as example
“Upper shaft is not at C point, Thread cut blade is not at stop position,
Thread Catcher is open position”, this key work for back to standby position
automatically.