HappyJapan HCR3E Series, Instruction Book

Page: 14 / 330

-3A -15 2-6b S604
2-6b
SETTING UP THE MACHINE
Removing of Removable table
and Border frame
1. Make sure that power source of the
machine is off.
2. Make sure that all Rotary hook
covers are shut.
If Rotary hook cover is not shut, the Table
will hit Rotary hook and damage it.
3. Remove all knob screw indicated in
arrow mark on back of the Border
frame and take out Border frame
slowly toward you as shown in Fig.
1.
4. Loosen all of the Knob bolts on the
reverse side of the Table slightly, pull
the Table prop B till it hits Stopper as
shown in Fig. 2.
5. Open all Clumps indicated by an
arrow mark as shown in Fig. 4, 5.
6. Unscrew set screws on Table stay
in order of center, right and left, then
pull out Removable table slowly
toward you.
To prevent the table from falling down, be sure to
take off set screws immediately before pulling out
the table.
7. Remove middle set screw on Table
stay, shrink Table stay as illustrated
in Fig. 8 and insert middle set screw.
8. As shown in Fig. 6, 7, insert
removable table to Bracket in order
of right, left and center (last time)
and slide it deep inside. Fix set
screws on each Table.
To prevent removable table from falling down, fix
screws immediately.
9. As shown in Fig. 6, tighten middle
set screw, shut all clamps, insert
Table prop and tighten knob bolts.
Upper set screw
Middle set screw
Table support
Removable table
Fig. 6
Clamp Fig. 5
Fig. 3
Fig. 8
Middle set screw
Upper set screw
Table stay
Combination of Table type and number of Clamp are depending
on model type.
Please rev erse procedure when fix the Table and the Border
frame.
Insert set screw lightly as shown in Fig. 1 for mounting Border
frame and tighten set screw pulling Border frame toward an arrow
mark (to your side).
Border frame
Knob screw
Fig. 1
Your side
Fig. 2
Knob bolts
Table prop
Stopper
Fig. 4
5
1 2
3 4
Table support
Fig. 7
Bracket