HappyJapan HCD3E, Instruction Book

Page: 22 / 362

-3A -28 3_9b S201
3-5
DRIVE MODE
4
Needle change
Change the needle bar directly to the indicated
needle number on the button.
Change
Move the sewing head to the adjacent needle in
the direction of the arrows.
Although the needl bar setting has been done,
needle bar setting is changed and pressed
, following dialogue will be displayed.
Needle bar setting will be changed
and the display will return to Drive mode.
Needle bar setting will not be changed
and the display will return to Drive mode.
Jump (Off)
The machine can embroider.
Jump (On)
Machine becomes jump and the machine
doesn’t embroider.
3
Frame forward
This creates direct designations to the position and
data to the designated sewing position.
Piece 9-C
If “Repeat” is set, this allows the frame to move to
the beginning of any piece at will.
Change (Color position ) 9-7
This moves the frame to the beginning of any Color
change number at will beginning of color.
Stitch (Number of stitches ) 9-6
This moves the frame to any stitch at will.
1
Drive speed
Control embroidery speed.
The speed can be controlled while embroidering.
Speed control
Press the + key to increase the machine sewing
speed and the - key to lower the machine speed.
is displayed on the LCD display.
2
Needle bar selection 5-E
For each color change in a given pattern, the needle number loaded with the correct color thread is as-
signed by the operator.
Low speed operation (OFF state)
Press the button to turn “ON” state.
Low speed operation (ON state)
The drive speed will be reduced to “200 rpm”.
Press the button to turn “OFF” state.
Speed setting by needle (OFF state)
3-8
Press the button to turn “ON” state.
Speed setting by needle (ON state)
Press the button to turn “OFF” state.
Color position forward
Move the frame to the beginning embroidery
position of the previous or later color position
number
Stitch number forward
Move the frame forward or backward by the
stitch number displayed in each button.
Bobbin thread alarm 9-Cb
Alarm message will be displayed when the re-
maining amount of bobbin thread becomes low.
Work save 9-Ce
Save the state of working design and selected frame.