HappyJapan HCD3E, Instruction Book

Page: 83 / 362

-RA -71
8-7
BORER (Option)
15_4 M717
1. Loosen the set screw and remove old borer
blade from bracket.
2. Please set position of Top of borer blade
3 mm higher than surface of Bracket, and
Cutting point of blade should be on front and
back, right and left.
Exchange the borer blade (option)
If the Borer blade become bunt or should chip, exchange the Blade in the following procedures.
CAUTION: To prevent accidents;
Please do not push up Blade guard by finger.
CAUTION: To prevent accidents;
B e sure power switch is “OFF”.
Bracket
Set screw
Borer blade
Top of Borer blade
3mm
Blade guard
Borer blade
Standard Borer blade position is that
position of Top of borer blade is 3mm higher
than surface of Bracket.
Depending on cutting result this height can
be adjusted between 0mm to 3mm.
Borer blade
Right
Left
Back
Front