HALE SmartFOAM 1.7AHP, Description, Installation And Operation Manual

Page: 79 / 93

Page 78
SmartFOAM
REMOTE ON/OFF SWITCH OPERATION
The remote ON/OFF switch is used to activate the Hale
SmartFOAM system from the driver compartment or a
location other than the SmartFOAM controller display. The
switch activates and deactivates the Hale SmartFOAM
system. It does not permit adjustment of the injection rate.
The SmartFOAM system will use the injection rate of the
preset set for “remote activattion” (see the
SETTING
PRESETS section). If no preset
has the “remote activation”
enabled then the injection rate used will be the current set
rate on the SmartFOAM controller.
See Figure 43
: Remote Activation Switch Installation
Dimensions .
To operate:
1. Press the switch down and release to activate. The
LED turns ON SOLID, indicating the Hale
SmartFOAM is in the STANDBY mode (see Figure
59
: Remote Activation Switch ).
2. When the foam capable discharge nozzle is opened
the LED BLINKS, indicating foam concentrate is
being injected. When the nozzle is closed, the LED
stops blinking and again turns ON SOLID.
3. Pressing the switch again deactivates the Hale
SmartFOAM system and the LED turns OFF.
Figure 59 : Remote Activation Switch
LED indications:
ON SOLID - The SmartFOAM system is enabled but waiting
for water flow before injecting foam.
BLINKING - The SmartFOAM system is enabled and
currently injecting foam.
OFF - The SmartFOAM system is disabled.