HALE SmartFOAM 1.7AHP, Description, Installation And Operation Manual

Page: 62 / 93

Page 61
SmartFOAM
CAUTION!
USE THE SILICONE SEALER PROVIDED TO INSULATE AND PREVENT CORROSION.
A connector kit (Hale p/n: 546-1780-00-0) is available that contains a Packard WeatherPack 2-contact shroud half, two (2)
14-16 gauge male terminals and two (2) 14-16 gauge cable seals. Assemble these components to the end of the low tank
sensor wires.
Snap the two halves of the WeatherPack connector together making sure they are sealed.
REMOTE ACTIVATION SWITCH OPTION
Choose a location in the apparatus personnel
compartment for mounting the remote activation switch.
Make sure the switch is accessible to the operator
without interfering with other controls on the apparatus.
Install the remote activation switch as follows:
1. Cutout the panel and drill the four 0.203 inch (5mm)
diameter through holes (see Figure 43
: Remote
Activation Switch Installation Dimensions ).
2. Insert switch assembly through the panel cutout and
secure to using the #10-
24 UNC x 1/2” (13mm) screws
and nuts provided.
Note: When making cable connections, make sure the
cable is routed by the shortest most direct route. A
maximum of 40 feet (12 meters) of remote cable may be
used.
3. Connect the remote activation switch cable from the
main cable harness connector C2 (see Figure 35
:
SmartFOAM Harness Connections
– Single Tank
or
Figure 36 : SmartFOAM Harness Connections
– Dual
Tank ).
Figure 43 : Remote Activation Switch Installation
Dimensions