HALE SmartFOAM 1.7AHP, Description, Installation And Operation Manual

Page: 54 / 93

Page 53
SmartFOAM
CONTROLLER UNIT POWER AND GROUND
CONNECTIONS
Power must be connected directly to the controller unit.
The power connection is the 2-pin Packard connector
(C5) of the controller harness (see Figure 35
:
SmartFOAM Harness Connections
– Single Tank
or
Figure 36 : SmartFOAM Harness Connections
– Dual
Tank ). The mating harness provided is approximately
18” (457mm) long. If additional wire length is required,
use minimum 16 AWG type SXL, or GXL (SAE J1128)
wire.
Connect the black (B) wire to a chassis ground stud.
Protect the ground connection from corrosion.
Connect the red (A) wire to the power supply. It is
recommended to connect the power wire to a minimum
5 AMP, fused, dedicated circuit. If a dedicated circuit is
not available, the power lead may be connected to a
terminal where there is not a HIGH current load.
Acceptable additional components powered from this
terminal include ENFO IV, Governor, Tank Level Gauge,
etc.
Figure 35 : SmartFOAM Harness Connections
– Single Tank