80
96-8000 Rev AC
May 2010
To re-activate the IPS option, scroll to the parameter bit as previously de
-
scribed, press the Emergency Stop button, type “1” and press Enter.
IPS Recorder
The IPS recorder provides a simple method to place G-code generated by IPS
into new or existing programs.
Operation
1. To access IPS, press MDI/DNC, then PROGRM/CONVRS.
2. When the recorder is available, a message appears in red in the lower right
corner of the tab:
.
MANUAL
SETUP
FACE
0
DRILL POCKET MILLING
ENGRAVING VQC
CENTER DRILL
0.0000 in
CENTER DEPTH
CENTER PECK
54
WRK ZERO OFST
X CENTER PT
0
DRILL TOOL
DRILL DEPTH
DRILL PECK
Y CENTER PT
R PLANE
0
TAP TOOL
TAP DEPTH
DIAMETER
ANGLE
0
NUM OF HOLES
0
CENTER HOLE
BOLT CIRCLE
BOLT LINE
SINGLE HOLE
0.0000 in
0.0000 in
0.0000 in
0.0000 in
0.0000 in
0.2000 in
0.0000 in
0.0000 in
0.000 deg
Press <CYCLE START>
to run in MDI or <F4>
to record output to a
program.
MULTIPLE HOLES
3. Press F4 to access the IPS recorder menu. Choose menu option 1 or 2 to
continue, or option 3 to cancel and return to IPS. F4 can also be used to return
to IPS from any point within IPS recorder.
.
0.0000 in
PLANE
NUM OF HOLES
IAMETER
CENTER HOLE
0.0000 in
0.2000 in
0
0
0
Press <CYCLE
to run in MDI or
to record outpu
program.
IPS RECORDER
F4 CANCEL
1. ) Select / Create Program
2. ) Output to current program
3. ) Cancel
IPS Recorder Menu
Summary of Contents for 96-8000
