135
96-8000 Rev AC
May 2010
G
&
M
Codes
Settings
ner rounding), as described in the G01 definition.
Using I, J, K addresses
I, J and K address are used to locate the arc center in relation to the start point.
In other words, the I, J, K addresses are the distances from the starting point
to the center of the circle. Only the I, J or K specific to the selected plane are
allowed (G17 uses IJ, G18 uses IK and G19 uses JK). The X, Y, and Z com
-
mands specify the end point of the arc. If the X, Y, or Z location for the selected
plane is not specified, the endpoint of the arc is the same as the starting point
for that axis.
To cut a full circle the I, J, K addresses must be used; using an R address
will not work. To cut a full circle, do not specify an ending point (X, Y and Z);
program I, J or K to define the center of the circle. For example: G02 I3.0 J4.0
(Assumes G17; XY plane)
Using the R address
The R-value defines the distance from the starting point to the center of the
circle. Use a positive R-value for radii of 180° or less, and a negative R-value
for radii more than 180°.
Programming Examples
.
1.5
135
O
R 1.00
.5Ø
225
O
.5Ø
1.5
R 1.00
G90 G54 G00 X-0.25 Y-.25
G01 Y1.5 F12.
G02 X1.884 Y2.384 R1.25
G90 G54 G00 X-0.25 Y-0.25
G01 Y1.5 F12.
G02 X1.884 Y0.616 R-1.25
Corner Rounding and Chamfering example:
G00 X1. Y1.
G01 Z-0.125 F30.
G01 X5 ,C0.75 F12
G01 Y1.75
G01 X6. ,C0.25
G01 Y5. ,R06.25
G01 X5.
G01 Y8. ,C0.5
G01 X1. ,R1.
G01 Y1.
G00 X0.75 Y0.75
Summary of Contents for 96-8000
