GRASS VALLEY TRINIX NXT -, Installation Manual

Page: 333 / 449

Trinix NXT — Installation and Service Manual 333
protectedPathsReset (void) Diagnostic use only.
Sets the ForceFileReadFlag. The flag causes the next
output card update from the device master to check the
status of the network redundancy device. If the device is
not active i.e. no network connection to another board
or the other board device master is not polling, PathInit
is called.
Otherwise it just clears the output initialized flags for
every output which requires both outputs in a path to
polled again to set them ready.
PathInit restores the protected path data from the
paths.dat file and initializes the output boost values for
restored paths. If the restore fails it initializes the data to
no paths. So if the paths.dat file is corrupted all paths
will be lost until enter on the paths web page is clicked.
returns OK
protectedPathsRestore (void) Reads the paths.dat file directly into the ProtectedOut-
putPath data structure.
Returns an error if the CRC check fails but will still
overwrite path data unless the file does not exist then
nothing will be read.
protectedPathsSave (void) Diagnostic use only.
Saves the current protected path data into the paths.dat
file.
Gets the current alarm level setting and puts it into the
flags at the maximum output number to save it with the
path data. Then calls PPShare to save the Protected-
OutputPath data structure array.
protectedPathsShare (void) Diagnostic use only.
Shares the protected paths.dat file with the other board.
The other board is either one IP address number higher
or lower than the board depending on whether the
board is in the primary or secondary slot.
Creates an FTP device to copy paths.dat to. A logMsg
will show if the copy fails but there are no other mes-
sages. Need to add system log events.
Table 72. R
Command Arguments Detailed Description
realtimeTaskShow (void) No Help Text (realtimeTask.cc)
redundancyDeviceShow (int what) Show redundant board communications
redundantConfigShow () No Help Text (redundantConfig.cc)
restartFpga (int nFrame, int nSlot) Restart FPGA code for the given frame and slot
If nFrame is -1 then restart all the FPGAs that need
restarted.
Example: restartFpga -1
If nFrame is -2 then force restart all the FPGAs.
Table 71. P
Command Arguments Detailed Description