GRASS VALLEY TRINIX NXT -, Installation Manual

Page: 352 / 449

352 Trinix NXT — Installation and Service Manual
Section 16 — Protected Paths
Figure 244. The Enter Button on the Signals: Protected Paths Web Page
4. Wait for a minute for the file to be copied. You can verify that the file
has been started using a Telnet session to the Secondary processor
address and then entering the following at the command prompt:
ll "/ata0"
5. Activate the secondary processor. (Enter the
redundancyBoardActivate
command from a console session or
press the button near the compact flash on the side with two buttons.
Figure 169 on page 264 )
Primary Broadlinx Board
Follow these steps to update the Primary Broadlinx board:
1.
Remove the Primary processor board and install the new compact flash
card on the primary board.
2.
Insert the Primary Broadlinx board back into the system and wait for
the Primary Broadlinx board to start.
3.
Connect to the Secondary Broadlinx controller from the Broadlinx Web
page
• Navigate to the Frame Signals Paths page and then click the
Enter
button to save the Protected Path data file to the new card in the
Primary slot.
4. Wait for the file to be copied.
5. Activate the Primary processor (Press the button near the compact flash
on the side with two buttons or evoke the
redundancyBoardActivate
command from a console shell.) and connect the Web browser to the
Primary processor to update the system firmware.