GRASS VALLEY TRINIX NXT -, Installation Manual

Page: 316 / 449

316 Trinix NXT — Installation and Service Manual
Section 13 — Broadlinx Software
TRX-NXT-512x512 Routing switchers
1. Connect to the Routing switcher following the procedure described on
page 311 .
2. Click on the graphic of the Routing switcher front panel.
3.
Click “Signals”
A menu similar to Figure 232 will then appear.
Figure 232.
Monitor Window (TRX-NXT-512x512).
The Monitor tab displays the following:
Chassis : This column lists the monitor output ports labeled “1” through
“4” on the back of the frame.
Output : This column lists the numbers that are entered in the control
system (for example, Jupiter) to identify the Trinix monitor outputs.
These numbers correspond to monitor output ports labeled 1 through 4 on
the rear of the frame (as shown in
Table 40 and Table 41 ).
Monitored : This column lists the number of the output that is being moni-
tored by the control system.
Switched : This column lists the number of the input that is being switched
to this monitor output.
Reclocker: (TRX-NXT-256x256 and TRX-NXT-256x256), this column lists
the following:
• “H” = The monitor output board is locked to (and is reclocking) an
HD signal.
• “S” = The monitor output board is not reclocking this signal
(because the signal is either SD or Force Bypass mode is selected).
For more information about output monitor reclocking see
Output
Monitor Reclock / Force Bypass Settings on page 206 .