Graseby 3000/500, Manual

Page: 218 / 231

Graseby Medical
Ltd
Volumetric Infusion Pumps
12 -
20
Issue 1(November 2001)
3000/3100 and 500/505 Ser
vice Manual
Command Code/Type and Name
Modes when command is not supported
Command Record Definition
Return Record Definition for 'Command Accepted' Return Code
I (CM) - CI Commands Enable/Disable
See ‘Entry to CI Mode’ under Command Code above.
<
LL
Itt
XXXX
> where:
tt = zero filled timer value in seconds. Valid
values:
00 – Inactivates timeout and disables CI
commands
05-60 – Sets timeout in seconds and
enables CI commands Notes: -Parameter is invalid if not one of the values/ranges outlined above. Receipt of any valid message resets the timer. (A valid record has a correct length field, correct CRC field, and is not less than the
minumim record length
allowed.) Timer will expire if a serial command is not received within the timeout time. Upon timeout, the processing covered in the section entitled ‘Exiting CI mode – Terminated vs. Disabled’.
<
LLRAAAAAA
aaaa.abbbb.bccc.c
XXXX
> where parameters are
as described for 'D' command response.
M (CM) - Pump Model Number Request
None.
<
LL
M
XXXX
>
<
LLRAAAAAA
eeeeff
XXXX
>
where:
eeee = '3000' or '3100' ff =
software version
in hexadecimal.
(For Example, 3F represents Rev
0.63)
Y (CM) - Pump Serial Number Request
None.
<
LL
Y
XXXX
>
<
LLRAAAAAA
aaaaaaaaa
XXXX
> where:
aaaaaaaaa is the 9 character pump id.
B (CI) - Silence Key Keypress
CI Commands Not Enabled, Power Off
<
LL
B
XXXX
>
<
LLRAAAAAA
aaaa.abbbb.bccc.c
XXXX
> where parameters are
as described for 'D' command response.