Graseby 3000/500, Manual

Page: 133 / 231

G r a s e b y M e d i c a l L t d .
8 — 4 I s s u e A ( A p r i l 2 0 0 2 ) 3 0 0 0 / 3 1 0 0 a n d 5 0 0 / 5 0 5 S e r v i c e M a n u a l
V o l u m e t r i c I n f u s i o n P u m p s
8
Door Rear - reassembly procedure for CE marked pumps ONLY, with serial
numbers 3000 to 59,999 and for ALL versions of pumps with serial
numbers from 60,000
To ensure ESD protection it is nessessary to follow the following
procedure when reassembling Door Rear, failure to do this may
result in damage to the LCD and/or Display board.
With the Door, Rear facing you, place a 1.5 inch (38 mm) strip of
kapton tape (part no. 26-1011-794-0) and align it to the hinge post and
door lip as shown in Figure 8.3A.
Fold the tape down onto the upper hinge bracket and upper spring
support as shown in Figure 8.3B. To avoid puncturing the tape it may
be nessessary to carefully recess the area shown in Figure 8.3B.
Using the kapton tape again cut a 4.5 inch (114 mm) strip and place
the tape horizontally down onto the upper hinge bracket and upper
hinge support covering the initial piece of tape, see Figure 8.3C.
Cut another 1.5 inch (38 mm) strip of kapton tape and place on the
lower left hand corner of the door, rear (spring support still facing
you). The lower hinge bracket should be covered as shown in Figure
8.3D. To avoid puncturing the tape it may be nessessary to carefully
recess the area shown in Figure 8.3D.
CAUTION: Do not damage or puncture the kapton tape. If the tape is damaged or punctured it could
result in the pump not being ESD protected. Special care should be taken when placing the
kapton tape and also when assembling the front and rear cases together as the front case
lugs may puncture the tape.
Figure 8.3 Door, rear - ESD protection for CE marked pumps only with serial numbers
3000 to 59,999 and for all versions of pumps with serial numbers from 60,000