![background image](http://html.mh-extra.com/html/goulds-pumps/xhd/xhd_installation-operation-and-maintenance-manual_2247661131.webp)
8.
Re-secure the bearing frame adjustment plates (234F) by tightening the hold down bolts (352G)
and nuts (427D).
6.4.6.17 Install suction side liner into suction half casing - Rubber-Lined
1.
Position the suction side liner (600R) inside the suction half casing (100A) so that the tapped holes
in the liner are aligned with the thru-holes in the casing.
2.
Insert the suction side liner retention studs (600L) through the suction half casing (100A) thru-holes
into the threaded holes of the suction side liner (600R) and secure with the retention stud nuts
(600N).
6.4.6.18 Install suction half casing with other suction half components
attached - Rubber-lined
During assembly, the casing bolts are typically inserted from the gland side of the wet end. This method-
ology can ease installation and tightening of flat washers and hex nuts when completing assembly of the
suction and gland halves of the wet end.
1.
Install the tapered alignment studs (600D) into the gland half casing (100D) in the locations shown.
2.
Attach the hoist hook to the suction half casing (100A) lifting lug.
3.
Lift the suction half casing (with other installed components) into place and move forward until the
casing halves are flush, using the tapered alignment studs (600D) as a guide.
4.
Install the flat washers (533) and tapered stud hex nuts (415B) on the forward face of the suction
half casing (100A).
5.
Insert the casing bolts (600A) into the remaining casing holes.
6.
Install the flat washers (553) and casing bolt hex nuts (600C) onto the casing bolts (600A) to com-
plete assembly of the casing halves.
6.4 Reassembly
XHD Installation, Operation, and Maintenance Manual
129
Summary of Contents for XHD
Page 1: ...Installation Operation and Maintenance Manual XHD ...
Page 2: ......