When the
reading val-
ue is...
Then...
Negative
The coupling halves are farther apart at the bottom than at the top. Perform one of
these steps:
•
Add shims in order to raise the feet of the driver at the shaft end.
•
Remove shims in order to lower the feet of the driver at the other end.
Positive
The coupling halves are closer at the bottom than at the top. Perform one of these
steps:
•
Remove shims in order to lower the feet of the driver at the shaft end.
•
Add shims in order to raise the feet of the driver at the other end.
X Y
Shims
Figure 21: Side view of an incorrect vertical alignment
4.
Repeat the previous steps until the permitted reading value is achieved.
4.5.5.2 Perform angular alignment for a horizontal correction
1.
Set the angular alignment indicator (A) to zero on left side of the driver coupling half (Y), 90° from
the top-center position (9 o’clock).
2.
Rotate the indicator through the top-center position to the right side, 180° from the start position
(3 o’clock).
3.
Record the indicator reading.
When the reading value is...
Then...
Negative
The coupling halves are farther apart on the right side than
the left. Perform one of these steps:
•
Slide the shaft end of the driver to the left.
•
Slide the opposite end to the right.
Positive
The coupling halves are closer together on the right side
than the left. Perform one of these steps:
•
Slide the shaft end of the driver to the right.
•
Slide the opposite end to the left.
Y X
Figure 22: Top view of an incorrect horizontal alignment
4.
Repeat the previous steps until the permitted reading value is achieved.
4.5 Pump-to-driver alignment
XHD Installation, Operation, and Maintenance Manual
35
Summary of Contents for XHD
Page 1: ...Installation Operation and Maintenance Manual XHD ...
Page 2: ......