Page 3-6
MDE-4771H Encore® S Enhanced FlexPay™ EMV® CRIND® Start-up/Service Manual · November 2019
Start-up and Configuration
Configuring Setup Menu and System Configuration Menu Parameters
Bundle 5X.Y.ZZ
To configure bundle 5X.Y.ZZ, proceed as follows:
Press
1
to set the contact card reader to “PANASONIC” (if not already set to “PANASONIC”).
To enable Contactless Card acceptance, press
2
to:
• Set Contactless Card Reader to “PANASONIC” (if not already set to “PANASONIC”), if
the contactless card reader connects to the Tribrid Card Reader (TCR).
• Set Contactless Card Reader to “OTI” (if not already set to “OTI”), if using the Gilbarco
Contactless Module (GCM) option.
Figure 3-12: System Config Menu for Bundle 5X.Y.ZZ
(i)
(ii)
6
Check if the correct printer port is selected [“COM3” if two-wire POS interface is used at the
site and “USB” if TCP/IP POS interface is used at the site].
7
Press
OK
to save changes and exit.
8
Press
CANCEL
to undo all the changes and exit.