Page 3-4
MDE-4771H Encore® S Enhanced FlexPay™ EMV® CRIND® Start-up/Service Manual · November 2019
Start-up and Configuration
Configuring Setup Menu and System Configuration Menu Parameters
Configuring Setup Menu and System Configuration Menu
Parameters
To configure the Setup Menu and System Configuration Menu parameters, proceed as follows:
1
Power up the FlexPay EMV CRIND and note the 8-digit Device Serial Number [Product Part
Number (PPN)], when the unit first powers up. The right-most six digits of the PPN is the
password for the Service Menu.
Note: Gilbarco recommends that Authorized Service Contractor (ASC) note down the PPN for
future reference. The PPN is also printed on the rear of the unit (see
on
Figure 3-7: Powering up FlexPay EMV CRIND
2
When the software package version numbers are shown, press
1
to enter setup.
Note: If the “<1> enter setup” option does not appear after 30 seconds to 1 minute, power
down the FlexPay EMV CRIND and power up the unit.
Figure 3-8: Software Packages Screen
<1> enter setup
appears at start-up and
also when the FlexPay card reader
requires activation
