MDE-4771H Encore® S Enhanced FlexPay™ EMV® CRIND® Start-up/Service Manual · November 2019
Page 3-3
Configuring CRIND IDs and CRIND Mode (CRIND Diagnostic Mode)
Start-up and Configuration
4
Press
1
>
Enter
. The CRIND ID side 1 screen opens.
Figure 3-5: CRIND ID Configuration Screen
5
Configure the CRIND ID for side 1 and press
Enter
to save the configured value and exit.
Note: To configure a two-digit CRIND ID, you must press Enter after entering each digit of
the CRIND ID. For example, to enter 12 as the CRIND ID, the key entries will be 1,
Enter, 2, Enter.
6
To configure the CRIND Mode, press
2
>
Enter
on the CRIND Config screen
(see
). The CRIND Mode screen opens.
Figure 3-6: CRIND Mode Screen
7
Press
1
>
Enter
to set the CRIND Mode to MOC or press
2
>
Enter
to set the CRIND Mode
to Generic.
8
Press
Enter
to save the configuration and exit.
