GF Hycleen Automation System, User Manual

Page: 46 / 57

4 Working with the master
4.7.4 Alarms Messages
The list in the area (1) displays the last messages.
For a system analysis, button (3) can be used to create a DMP file and import it onto a
USB stick. The file contains the commands carried out in the master and can provide
information in case of an unexpected event. For this purpose, the DMP file can be sent
to the technical customer service via e-mail, see
Troubleshooting .
If button (3) is not active, no USB stick is detected. In this case make sure that the USB
stick is correctly inserted and, if required, use a USB stick of another make.
Button (2) closes the dialog.
4.7.5 Update
The update of the master with a new firmware is protected by a password: 42.
We provide software updates as a zip archive. These must be copied to a USB stick in
their original condition.
During the update you must agree to the general terms and conditions and our non-
liability disclaimer, otherwise the process is abandoned. The software shows step by
step instructions.
After the update of the firmware remove the USB stick and restart the master.
For this purpose, switch the power to the master and any connected power-
boxes off and on again.
The new software is also installed on the controllers of the connected valves.
This process takes a few minutes (about 30 seconds per controller).
The update is completed as soon as the following message is shown: "Firmware
update of the valves is completed."
If the software update is not successfully completed, the current master software
remains active and unimpeded functional.
46