GF Hycleen Automation System, User Manual

Page: 15 / 57

3 Installation
Sub-standard assembly can cause malfunctions!
If the knurled screw is not tightened correctly, the connection can work loose
over time. This causes the system to malfunction!
Make sure that all knurled screws of the connecting cables are
tightened!
Sub-standard assembly can cause malfunctions!
If powerboxes are installed, these components provide voltage even when the
master is switched off.
Make sure that all powerboxes are first switched off before switching off
the master!
Make sure that all powerboxes are first switched on again before switch-
ing on the master!
Sub-standard assembly can cause malfunctions!
The master must be switched off during the connection of new external
sensors.
Switch off all powerboxes before switching off the master.
Switching off the master.
Connect the sensors with the master as described below.
Switch on all powerboxes again before switching on the master.
Switch on the master again. This first initializes all connected power-
boxes and then launches the master software. The newly connected
external sensors are now automatically detected by the master.
15