Revolving door TSA 325 NT
32
Options
X
Adjust the turnstile so that the leaves are not positioned under the locking systems.
X
Use the manual unlocking (hexagon size 6) (see section 5.1.1 Components on page 28, Item 7) to position
both locking systems completely at the bottom.
X
Turn the turnstile until at least one of the two locking systems latches in.
X
If necessary, adjust the locking system that does not yet latch in correctly by means of the oblong holes as
described above so that it also latches in correctly.
X
Use the manual unlocking to position the locking systems at the top again and repeat the process until both
locking systems latch in when the turnstile is turned.
5.1.6 Adjusting the switching points
Adjusting of the switching points is used to specify the respective end points (locked/unlocked) of the locking bolt.
If the switching points are set incorrectly, the switching contacts are not operated at the end points of the lock-
ing system so that malfunctions can occur.
X
Loosen the setscrews (3) of the two operating cams (4) and (5) on the extended motor axis of the locking unit.
Adjusting the locked position:
X
Use the hexagon of the manual unlocking (6) to
move the locking bolts completely downwards.
X
Turn operating cam 1 (4) in the direction of
rotation of the motor axis (see arrow) on the limit
switch (2) until it triggers the contact (click noise).
X
Tighten the setscrew (3) of operating cam 1 (4) again.
Adjusting the unlocked position:
X
Use the hexagon of the manual unlocking (6)
to move the locking bolts completely upwards.
X
Turn operating cam 2 (5) in the direction of
rotation of the motor axis (see arrow) on the limit
switch (1) until it triggers the contact (click noise).
X
Tighten the setscrew (3) of operating cam 2 (5)
again.
