X500pro
3D printer manual
DRAFT
German
RepRap
Operating Mode
When the X500pro is connected to the power supply you can start your printer by using the main switch at
the back (red turn). By default the printer is in this operation mode.
After a short initialization phase the start-up screen appears on the display and the printer is ready to use.
In this mode you can upload G-Codes, heat up the machine and traverse the axis.
ATTENTION: If you open the lid
while a 3D print is currently running the printer will shut down immediately and the
executed print is lost - if you don’t use the foot paddle. By holding the middle position , the door can be opened. Be
careful it is intentionally that the 3rd position (full pressed) can be reached easily which will lead to a print job loss.
Maintenance Mode
When operating in maintenance mode, it is possible to work with an open maintenance lid. This mode is
intended for repair and maintenance work only! The maintancane mode is switched with a key in the elec-
tronic compartment.
The maintenance mode must be set up by a trained professional only!
WARNING:
Surfaces
as well as the
extruder
and
printed object
will remain hot for
some time after the printer shuts down.
service key switch in electro panel
foot panel to bridge temporary the safety control
11/83
